GATEWAY Laptop Auto(DC) Adapter Articles & Tips
A new GATEWAY Laptop Auto(DC) Adapter comes in a discharged condition and must be charged before use (refer to the devices manual for charging instructions). Upon initial use (or after a prolonged storage period) the digital camcorder GATEWAY may require three to four charge/discharge cycles before achieving maximum capacity. New GATEWAY needs to be fully charged and discharged (cycled) a few times before it can condition to full capacity. Rechargeable batteries undergo self-discharging when left unused. Always store a camcorder battery pack in a fully charged staged for storage.When charging the GATEWAY for the first time the device may indicate that charging is complete after just 10 or 15 minutes. This is a normal phenomenon with rechargeable batteries. Remove the camcorder batteries from the device, reinsert it and repeat the charging procedure
It is important to condition (fully discharge and then fully charge) the GATEWAY every two to three weeks. Failure to do so may significantly shorten the battery's life (this does not apply to Li-Ion batteries, which do not require conditioning). To discharge, simply run the device under the battery's power until it shuts down or until you get a low battery warning. Then recharge the battery as instructed in the user's manual. If the battery will not be in use for a month or longer, it is recommended that GATEWAY be removed from the device and stored in a cool, dry, clean place.
Invest in a good charger for your camcorder. NiMH batteries should not be charged in a NiCad charger, unless the charger is specifically made for both chemistries. There are cheap chargers and there are expensive chargers. Make sure the charger you get has good reviews and is well made. Chargers with micro-controller chips are usually the best choice of your digital camcorder.
Be sure to store your Laptop Auto(DC) Adapter properly. Do not leave your batteries in a hot car, or in humid conditions. The best storage conditions are a cool, dry place. The refrigerator is fine if you stick in a packet of silica gel with your GATEWAY in a sealed bag to keep them dry. It is a good idea to charge your NiCad or NiMH batteries fully before use if they have been in storage.
How can I maximize the performance of my GATEWAY Laptop Auto(DC) Adapter?
There are several steps you can take to help you get maximum performance from your Laptop Auto(DC) Adapter:
Prevent the Memory Effect - Keep the Laptop Auto(DC) Adapter healthy by fully charging and then fully discharging it at least once every two to three weeks. Exceptions to the rule are Li-Ion batteries which do not suffer from the memory effect.
Keep the GATEWAY Laptop Auto(DC) Adapter Clean - It's a good idea to clean dirty battery contacts with a cotton swab and alcohol. This helps maintain a good connection between the battery and the portable device.
Exercise the Battery - Do not leave the battery dormant for long periods of time. We recommend using the battery at least once every two to three weeks. If a Laptop Auto(DC) Adapter has not been used for a long period of time, perform the new battery break in procedure described above.
Battery Storage - If you don't plan on using the Laptop Auto(DC) Adapter for a month or more, store it in a clean, dry, cool place away from heat and metal objects. NiCad, NiMH and Li-Ion batteries will self-discharge during storage; remember to recharge the batteries before use.
Understanding your GATEWAY Battery Needs
We strive to make you Laptop Auto(DC) Adapter purchases easy. Since we understand that finding the right batteries for your needs can be overwhelming and confusing at times we developed a Laptop Auto(DC) Adapter finder tool to help find the right size for the make and model of your equipment. We also offer educational articles and tips to help you conserve your batteries and understand common problems. By us providing education you are able to make the right purchasing decisions as well as provide proper care for all of your electronics.
|
Warranty Policy